Ibis Mojo HD5 NX Eagle Mountain Bike 2020 - Brown

final 0rrp4899.000000
RRP $7,005.57
Save $7,005.57
SAVE 14%

The Mojo HD5 is proof that descending prowess doesn't have to limit climbing capability.


Please note: the image is for illustration purposes only and may differ from actual spec, please check the details tab for full specification.


Enduro World Series tested and team-approved, the HD5 lives for ragged descents combined with real-world climbs requiring efficiency, positioning and poise. Which it delivers in spades. It’s the ultimate 27.5” brawler, living to ride as hard up as down with 153mm of dw-link controlled travel and a 170mm fork. 76 degrees of climbing we'd like you to meet 64.2 degrees of descending.


DW LINK
Since 2005, we've partnered with suspension guru Dave Weagle on the dw-link suspension platform. It provides an unparalleled combination of climbing efficiency and downhill performance, that has been proven repeatedly at the highest levels of racing.


TRACTION TUNE
Our custom tuned front and rear suspension feature extra light high speed compression and rebound damping to deliver unparalleled traction. This allows the wheels to flutter through terrain like a trophy truck storming through a set of whoops.


LIGHTWEIGHT PREMIUM CARBON
Whether you order an XTR or NX kit, you'll get the same premium carbon fibre frame. All our bikes are built from the highest-grade materials and optimised for the best strength, weight, stiffness, and ride performance.


PICK YOUR SIZE
We use names like small, medium, and large to describe our sizing because it's easy to understand, but our ultra-low standovers and clearance for long droppers give you the ability to size based on reach.

 

FORK OFFSET
Reduced-offset forks give the front wheel greater stability at speed and an additional sense of steadiness at slow speeds too. Since the HD5 is designed to excel in technical, demanding terrain, we went with a reduced, 37mm-offset fork to give that extra bit of confidence and control in the most challenging situations.

 

2.6" TYRE CLEARANCE
Ibis helped pioneer the wide rim revolution, which inspired the new crop of wider 2.4"-2.6" tyres. When paired together, this combo can be run at ultra low pressures which results in elbow-dragging cornering traction without sacrificing straight line speed.

 

INTERNAL CABLE TUNNELS
Internal cable routing used to be a pain but our internal tubes make routing easy. Just pop the housing through and it comes out the other end, no need for swear words or a pickset. It's clean and easy. As it should be.


LONG DROPPER POST
What's better than a dropper post? A longer one. Our frames are designed to accommodate the longest dropper posts possible. Riders over 5'8 (or 173cm) can easily run a 185mm dropper post, while folks between 5' and 5'8 (152cm-172cm) can use a post 125mm or longer depending on inseam length.


LINKAGE PROTECTION
It's all about the little details. To keep your bike looking and performing at its best, we've fortified the upper pivot with a steel guard and added a plastic fender about the lower link. The HD5 also ships with a polycarbonate downtube protector and moulded rubber swing arm protectors.


REMOVABLE ISCG 05 MOUNT
There if you want it, removable if you don't.


Features:

  • FOX FLOAT 36 Performance Series, 37mm offset, 170mm
  • FOX FLOAT DPX2 Performance Series, EVOL
  • SRAM NX Eagle, 12-speed
  • SRAM Guide T, 4-piston
  • KS Rage-i dropper


Full specification available in the details tab.

More Information
Model Number IBISMHD5NXBWN20
Brand Ibis
Colour Brown
Gender Womens, Mens
Age Adult
Model Year 2020
Frame Carbon Fiber Monocoque, polycarbonate downtube protector, molded rubber swing arm protectors
Fork FOX FLOAT 36 Performance Series, 37mm offset, 170mm
Rear Shock FOX FLOAT X2 Factory, 7.875" x 2.25"
Shifters SRAM NX Eagle, 12-speed
Derailleur (Rear) SRAM NX Eagle, 12-speed
Brakes SRAM Guide T, 4-piston, SRAM Centerline rotors (200mm front, 180mm rear)
Brake Levers SRAM Guide T
Crankset SRAM NX Eagle, DUB spindle w/ SRAM NX Eagle, 32 tooth steel
Cassette SRAM PG 1230 Eagle, 12-speed, 11-50 tooth
Chain SRAM NX Eagle, 12-speed
Bottom Bracket SRAM DUB BSA, 73mm English threaded
Hub Front 110x15mm Boost front,
Hub Rear Ibis148x12mm Boost rear
Rims Ibis S35 aluminum
Tyres Maxxis Assegai, EXO+ casing, 27.5” x 2.5” WT
Handlebar Ibis alloy, 31.8mm clamp diameter, 780mm width
Stem Ibis, 31.8mm clamp diameter
Headset Cane Creek 40, ZS44 upper, ZS56 lower
Saddle WTB Silverado Pro, 142mm width
Seatpost KS Rage-i dropper
Pedal Not incl.
Wheel Size 27.5inch
Number of Gears 12
Ready to ride
Every bike from Start Fitness is fully checked & assembled before despatch and will arrive, almost, ready to ride. Each bike is assembled by one of our CyTech accredited mechanics and then packed into one of our custom boxes. Minimal assembly, with basic tools, is required before you can ride. Assembly tools are not usually included. More details can be found here.
Please note: Some bikes are not supplied with pedals. Manufacturers don’t know if you want flat or clipless pedals, rather than send the bike with the wrong type, they leave the choice for you to make.
 
This process has a lead time of between 5 to 7 working days
Unfortunately during peak times this may be slightly delayed. We will however, aim to despatch your bike as quickly as possible.
 
 
Making sure you are home
Once fully checked and boxed, we will contact you to book a delivery date. Our bikes are despatched on a next working day service (excludes weekends & bank holidays) for UK mainland orders, or a two day service to Northern Ireland and outlying Scottish areas. European bike deliveries usually take approximately one week.
 
Taking Delivery
Any mechanical or cosmetic issues need to be reported to us within one week of the delivery date. If you do not plan on using the bike straight away, we advise that you remove it from the box and check it over ASAP as we cannot be responsible for any reported issues (other than standard warranty issues) later than one week from the date that the bicycle was delivered.
 
First Check-Over
After a few weeks of riding (depending on riding style and conditions), a new bike will need a check-over to make final adjustments and to re-check all nuts and bolts. This is necessary as the bike goes through a ‘bedding in’ phase after which, final adjustment may be necessary. We recommend that this is carried out by a CyTech qualified mechanic. It is important to have these checks carried out to prevent any avoidable problems which may not be covered by warranty and to ensure the smooth running of the bicycle.
 
We can carry out the first check-over free of charge, at our Newcastle store (NE16JE). If you’ve had the bike delivered, it will be your responsibility to get the bicycle to and from our store for this work to be carried out. This complimentary check-over does not include any labour to replace worn parts or to fit new accessories.
 
All bikes must be booked in for the first service & must be clean or a £15 cleaning charge will be payable. You can book this by calling 0191 261 4191. Proof of purchase will need to be presented when the bicycle is dropped off for the first check-over.
 
Bike Servicing
Bicycles need to be serviced regularly, as a guideline we would advise on at least one full service per year and/or a standard service twice a year. If the bike is used regularly in adverse conditions, more regular servicing may be required.
Write Your Own Review
You're reviewing:Ibis Mojo HD5 NX Eagle Mountain Bike 2020 - Brown
Your Rating